Basic Lathe Anatomy

The following content is syndicated content.

Basic Lathe Anatomy

posted on July 29, 2014 by Rockler

Basic Lathe Anatomy Guide
details to know

Morse taper: This refers to the tapered interior of the headstock spindle and tailstock spindle.  Most woodturning lathes will have either an MT-1 or MT-2 spindle taper, with MT-2 being the most common. It’s important to know your lathe’s Morse taper in case you want to buy accessories such as after-market spur or live centers, a Jacobs chuck or a mandrel for turning pens.

Headstock spindle size and TPI: Knowing these specifications is important when you want to add a four-jaw chuck to your lathe. Most four-jaw chucks require an adapter to mount to the lathe, and these must match the headstock spindle. Common headstock spindle sizes are 3/4″ x 16TPI, 1″ x 8TPI and 1-1/4″ x 8TPI.

Faceplate: Typically included when you buy a lathe, the faceplate threads onto the drive spindle and has holes for mounting bowl blanks with screws.

Swing over the bed: This is twice the distance from the tip of the drive center down to the lathe bed. It you the maximum diameter that can be turned on that lathe.

Distance between centers: This is the distance between the drive or spur center on the headstock and the rotating center in the tailstock when the tailstock has

… Continue reading here.

Tags: , , , , ,
Previous Post

Check out: CH Hanson 03040 Magnetic Stud Finder

Next Post
Do It Yourself Project

Kitchen Remodel Part 4

Leave a Reply